![]() Royalty-Free Stock Photo Show Image Detail Freshly caught Bluefish on the sand on the beach in Melbourne Beach, Florida Royalty-Free Stock Photo Show Image Detail A white caucasian man 60 years old with a pompano and a bluefish in his hands stands on a wooden staircase against the backdrop of the Atlantic Ocean, having returned from fishing. i just let my imagination run away with me.Īll dive plain and ruder made out of brass.Īlso have got a 3rd servo installed for rear dive plain controlĪll and all apart from looking very dusty she is a fine performer.Show Image Detail Bluefish (Pomatomus saltatrix) - A 7 pound bluefish caught surfcasting along the shores of Martha's Vineyard during the fall run Royalty-Free Stock Photo Show Image Detail Single sea fish (bluefish, Pomatomus saltatrix) isolated on white, top view Royalty-Free Stock Photo Show Image Detail Fresh fish bluefish with ice, salt and lemon on a blue background Royalty-Free Stock Photo Show Image Detail Bluefish -Pomatomus saltatrix-, isolated on white background Royalty-Free Stock Photo Show Image Detail bluefish on a white background Royalty-Free Stock Photo Show Image Detail Bluefish ( Latin Pomatomus Saltatrix ) isolated on white Royalty-Free Stock Photo Show Image Detail Bluefish (Turkish: Cinekop-Lufer) cooked on the barbecue. ![]() Oh i forget to mentioning in case you where wondering,my u-boats always end up looking different from stock.of course i can build them from spec if i wish to do so. Here are some pictures of what i done up to now I have tested the sub under water and it keeps the water out ok the lid can be removed at any time if needed,thats why i used allen screws. Then i also cut a inspection hole in to the lid,so i can charge my batteries etc etc.Īll you got to do then is to seal the lid around the edges,where it meets the shell. What i done getting the electronic compartment watertight is,i screwd and glued a peace of wood on to each bulkhead with 2 threaded inserts driven in to the bottom of the wood (each peace of wood).then i used a peace of perspect sheet to go right across from one bulkhead to the other sealed underneath and used allen screws to tighten it down. Yes i also build a bluefish,took me almost 4 years to complete on and of and still haven't finish it, luck of time i guess. The minor flaws were then filled with spot glazing putty and sanded to prep for prime. Once fully cured, the outer lip was cut off and the seem filled with Bondo and sanded. Once dry, the strip was painted with West Systems resin. The strip was tacked in place by brushing weld cement into the strip and and pressing it into the softened plastic. The seam was then reinforced on the inside with the provided fiberglass strip. The halves were claped together using stationary clamps and glued using Ambroid Pro Weld liquid cement. The parts were cut from the carrier sheet leaving a 1/4" lip all the way around, with the exception of the cutout at the top. As the build progresses I'll cover the changes in detail.Ĭonstruction began with joining the hull halves. This one is a completely different animal then the Akula, I think it'll work just fine.īefore the build began I had the oppertunity to sit down with Tom from Dumas for a couple hours and talk about the shortcomings of the original design, and plan the strategy around those problems. After building the Dum,as Akula and then fabricating the Hunly from the Akula inner workings I thought that the Bluefish might be a fun build as well.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |